No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Advanced O&M Command Reference

OceanStor 5000, 5000F, 6000, and 6000F V5 Series V500R007

This document is applicable to OceanStor 5110 V5, 5110F V5, 5300 V5, 5500 V5, 5600 V5, 5800 V5, 6800 V5, 5300F V5, 5500F V5, 5600F V5, 5800F V5, and 6800F V5. Based on the CLI, this document describes how to use various commands classified by functionsand how to set the CLI and manage the storage system through these commands.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
xnet showqueuemsg

xnet showqueuemsg

Function

The xnet showqueuemsg command is used to view information about messages of the xnet module in the PCIe queue.

Format

xnet showqueuemsg [ -f ]

Parameters

Parameter

Description

Value

-f

Prints message information in the queue to the message log.

-

Views

Diagnostic view

Usage Guidelines

  • This command is used by development engineers to locate faults.
  • When XNET messages fail to be sent or scheduled, you can run the command to view messages in the PCIe queue.

Example

  • View information about messages in the current PCIe receiving queue.
    admin:/diagnose>xnet showqueuemsg 
    Pid SelfQ  SentQ  CtrlMsg DataMsg TotalCount 
    ------ ------ ------ ------ ------ ------
  • View information about messages in the current PCIe receiving queue and print the information to the message log.
     admin:/diagnose>xnet showqueuemsg -f  
    Pid             SelfQ           SentQ           CtrlMsg         DataMsg         TotalCount 
    ------          ------          ------          ------          ------          ------ 
    228             0               37              0               37              37

System Response

The following table describes the parameter meanings.

Parameter

Meaning

Pid

Module ID.

SelfQ

Count of messages of a module in SelfQ.

SentQ

Count of messages of a module in SentQ.

CtrlMsg

Count of control messages of a module in the queue.

DataMsg

Count of data messages of a module in the

queue.

TotalCount

Total of messages of a module in the queue.

Translation
Download
Updated: 2019-07-11

Document ID: EDOC1000181619

Views: 586944

Downloads: 233

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next