No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Advanced O&M Command Reference

OceanStor 5000, 5000F, 6000, and 6000F V5 Series V500R007

This document is applicable to OceanStor 5110 V5, 5110F V5, 5300 V5, 5500 V5, 5600 V5, 5800 V5, 6800 V5, 5300F V5, 5500F V5, 5600F V5, 5800F V5, and 6800F V5. Based on the CLI, this document describes how to use various commands classified by functionsand how to set the CLI and manage the storage system through these commands.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).


The command is used to modify the bay_config.ini file, including the enclosure ID, number of controllers, and IP address bytes.

Format { -i BayID | -c ControllerTotal | -t BayType }* [ -n ] [ -l ] [ -s ] [ -d | -a ]






Indicates an enclosure ID.

The value ranges from 0 to 7.


Indicates the number of clusters.

The value ranges from 1 to 16.


Indicates an enclosure type.

The value can be 0, 1, or 2.

  • 0: disk enclosure with 2.5-inch disks.
  • 1: disk enclosure with 3.5-inch disks.
  • 2: disk enclosure with both 2.5-inch and 3.5-inch disks.


Indicates that the enclosure ID is not written to the backplane.This parameter is invalid currently.



Indicates that bay_conf.ini is not synchronized to the peer controller.



Synchronizes to the second backup point.This parameter is invalid currently.



Deletes IP address bytes.



Adds default IP address bytes.



Minisystem mode

Usage Guidelines



Modify the bay_config.ini file of local and remote controllers.

Storage: minisystem> -i 0 -c 2 -t 0 -a 
Write bay config to startup disk successfully.

System Response


Updated: 2019-07-11

Document ID: EDOC1000181619

Views: 631104

Downloads: 252

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next