No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Advanced O&M Command Reference

OceanStor 5000, 5000F, 6000, and 6000F V5 Series V500R007

This document is applicable to OceanStor 5110 V5, 5110F V5, 5300 V5, 5500 V5, 5600 V5, 5800 V5, 6800 V5, 5300F V5, 5500F V5, 5600F V5, 5800F V5, and 6800F V5. Based on the CLI, this document describes how to use various commands classified by functionsand how to set the CLI and manage the storage system through these commands.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
showdisk

showdisk

Function

The showdisk command is used to show the disk status.

Format

showdisk

Parameters

None

Modes

serial port mode

Usage Guidelines

None

Example

Run the "showdisk" command to show the status of disks managed by the SES_A management system on a high-density disk enclosure.

PANGEA_SES_A:>showdisk 
disk 00 01 02 03 04 05 06 07 08 09 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 
status  5S 4S 0  5S 5S 4S 1  4S 4S 4S 4S 
power 2  2  3  2  2  2  2  2  2  2  2 
present 1  1  0  1  1  1  1  1  1  1  1

System Response

The following table describes the parameter meanings.

Parameter

Meaning

disk

Disk slot ID. The value ranges from 0 to 31.

status

Disk status. The value consists of digits and letters, or only digits. The digit indicates the data transfer rate of disks. 5 indicates 12 Gbit/s. 4 indicates 6 Gbit/s. 3 indicates 3 Gbit/ s. 2 indicates 1.5 Gbit/s. 1 indicates that a disk is present but the data transfer rate is 0. 0 indicates that no disk is present. The letter indicates the disk type. S indicates SAS disks. T indicates SATA disks.

power

Power status of the disk slot.

2 indicates that the disk slot is powered on.

3 indicates that the disk slot is powered off.

Vacant disk slots are powered off.

present

Present status of the disk. 0 indicates absent and 1 indicates present.

Translation
Download
Updated: 2019-07-11

Document ID: EDOC1000181619

Views: 639115

Downloads: 256

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next