No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Advanced O&M Command Reference

OceanStor 5000, 5000F, 6000, and 6000F V5 Series V500R007

This document is applicable to OceanStor 5110 V5, 5110F V5, 5300 V5, 5500 V5, 5600 V5, 5800 V5, 6800 V5, 5300F V5, 5500F V5, 5600F V5, 5800F V5, and 6800F V5. Based on the CLI, this document describes how to use various commands classified by functionsand how to set the CLI and manage the storage system through these commands.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
change disk clearerrordlt

change disk clearerrordlt

Function

The change disk clearerrordlt command is used to clear the DLT information about a specified disk.

Format

change disk clearerrordlt { sdid=? | disk_id=? }

Parameters

Parameter

Description

Value

sdid=?

Physical ID of the disk.

The value ranges from 64 to 4000. To obtain the value, run the sddebug show disk command in the diagnostic view.

disk_id=?

Disk ID.

To obtain the value, run "show disk general".

Views

Developer view

Usage Guidelines

None

Example

  • Clear the DLT information about the disk whose physical ID is 65.
    developer:/>change disk clearerrordlt sdid=65 
    DANGER: You are about to clear the DLT information about the disks, which may result in a failure of the disks. 
    Suggestion: Note the following before and after the command execution: 
    1. Ensure that the command is to be executed by the R&D personnel. 
    2. This command will clear the DLT information about the disks, which may result in a failure of the disks. 
    3. After executing this command, check whether the service system is running correctly. 
    Have you read danger alert message carefully?(y/n)y 
    Are you sure you really want to perform the operation?(y/n)y 
    Command executed successfully.
  • Clear the DLT information about the disk whose ID is "DAE008.10".
    developer:/>change disk clearerrordlt disk_id=DAE008.10 
    DANGER: You are about to clear the DLT information about the disks, which may result in a failure of the disks. 
    Suggestion: Note the following before and after the command execution: 
    1. Ensure that the command is to be executed by the R&D personnel. 
    2. This command will clear the DLT information about the disks, which may result in a failure of the disks. 
    3. After executing this command, check whether the service system is running correctly. 
    Have you read danger alert message carefully?(y/n)y 
    Are you sure you really want to perform the operation?(y/n)y 
    Command executed successfully.

System Response

None

Translation
Download
Updated: 2019-07-11

Document ID: EDOC1000181619

Views: 635884

Downloads: 256

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next