No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Advanced O&M Command Reference

OceanStor 5000, 5000F, 6000, and 6000F V5 Series V500R007

This document is applicable to OceanStor 5110 V5, 5110F V5, 5300 V5, 5500 V5, 5600 V5, 5800 V5, 6800 V5, 5300F V5, 5500F V5, 5600F V5, 5800F V5, and 6800F V5. Based on the CLI, this document describes how to use various commands classified by functionsand how to set the CLI and manage the storage system through these commands.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
os_change_bayconfig.sh

os_change_bayconfig.sh

Function

The os_change_bayconfig.sh command is used to modify the information about bay config saved on the BMC for the information to take effect.

Format

os_change_bayconfig.sh { delete | change | set | sync }

Parameters

Parameter

Description

Value

delete

Deletes the information about bay config from the BMC. The parameter only applies to 3 U and 6 U devices instead of 2 U devices.

-

change

Reads the configuration information from a disk and writes the information into the BMC.

-

set

Reads the BayConfig.ini file from the BMC and writes the information into memory and disks. If the information fails to be read from the BMC,read it from disks and writes it into memory for it to take effect. The parameter only applies to 3 U and 6 U devices instead of 2 U devices.

-

sync

Writes the bay config file into the disks.

-

Modes

Minisystem mode

Usage Guidelines

None

Example

To change the configuration of bay config saved on a BMC, run the following command.

Storage: minisystem>os_change_bayconfig.sh change 
[os_change_bayconfig.sh]: Execute os_change_bayconfig.sh success.

System Response

None

Translation
Download
Updated: 2019-07-11

Document ID: EDOC1000181619

Views: 631877

Downloads: 252

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next