No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Advanced O&M Command Reference

OceanStor 5000, 5000F, 6000, and 6000F V5 Series V500R007

This document is applicable to OceanStor 5110 V5, 5110F V5, 5300 V5, 5500 V5, 5600 V5, 5800 V5, 6800 V5, 5300F V5, 5500F V5, 5600F V5, 5800F V5, and 6800F V5. Based on the CLI, this document describes how to use various commands classified by functionsand how to set the CLI and manage the storage system through these commands.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
change system work_mode

change system work_mode

Function

The change system work_mode command is used to switch the system working mode. This command is used when you want to switch the system working mode.

Format

change system work_mode environment_mode=?

Parameters

Parameter

Description

Value

environment_mode=?

Working environment mode that what you want to set.

The value can be "normal_mode" or "atrocious_mode", where:

  • "normal_mode": indicates the normal working environment mode.
  • "atrocious_mode": indicates the atrocious working environment mode.

Views

Developer view

Usage Guidelines

None

Example

Switch the system working environment mode to "atrocious_mode".

developer:/>change system work_mode environment_mode=atrocious_mode 
WARNING: You are about to change the system working mode. This operation has the following risks: 
1. If you are about to enable the atrocious mode, the self-protection function of the system will be disabled. The system continues to work in high-temperature and low-temperature environments, which may cause equipment damage. 
2. If you are about to disable the atrocious mode, ensure that no level-2 high-temperature alarm exists. Otherwise, the controller that has the level-2 high temperature alarm will be powered off, and services may be interrupted. 
Suggestion: Before performing this operation, ensure that you really need to switch the working mode. 
Have you read warning message carefully?(y/n)y 
Are you sure you really want to perform the operation?(y/n)y 
Command executed successfully. 
developer:/>

System Response

None

Translation
Download
Updated: 2019-07-11

Document ID: EDOC1000181619

Views: 615735

Downloads: 244

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next