No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Advanced O&M Command Reference

OceanStor 5000, 5000F, 6000, and 6000F V5 Series V500R007

This document is applicable to OceanStor 5110 V5, 5110F V5, 5300 V5, 5500 V5, 5600 V5, 5800 V5, 6800 V5, 5300F V5, 5500F V5, 5600F V5, 5800F V5, and 6800F V5. Based on the CLI, this document describes how to use various commands classified by functionsand how to set the CLI and manage the storage system through these commands.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
change repair configuration

change repair configuration

Function

The change repair configuration command is used to configure the current bad sector repair function.

Format

change repair configuration [ enabled=? ] [ verify_period=? ] [ verify_times=? ]

Parameters

Parameter

Description

Value

enabled=?

Whether to enable bad sector repair.

The value can be "yes" or "no", where:

  • "yes": to enable bad sector repair.
  • "no": not to enable bad sector repair.

verify_period=?

Cycle of enabling bad sector repair.

The value ranges between "0" and "600", expressed in seconds.

verify_times=?

Number of times to enable bad sector repair.

The value ranges between "0" and "30".

Views

Developer view

Usage Guidelines

None

Example

To configure the current bad sector repair function, run the following command:

developer:/>change repair configuration enabled=yes verify_period=100 verify_times=6 
WARNING: You are going to adjust bad sector repair parameters. The bad sector repair parameters include bad sector verification period and times. If the times of the periodical verification failure reaches the set value, the disk containing the bad sector is failing. 
Suggestion: Perform this operation based on system reliability need. 
Have you read warning message carefully?(y/n)y 
Are you sure you really want to perform the operation?(y/n)y 
Command executed successfully. 
developer:/>

System Response

None

Translation
Download
Updated: 2019-07-11

Document ID: EDOC1000181619

Views: 634330

Downloads: 254

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next