No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Advanced O&M Command Reference

OceanStor 5000, 5000F, 6000, and 6000F V5 Series V500R007

This document is applicable to OceanStor 5110 V5, 5110F V5, 5300 V5, 5500 V5, 5600 V5, 5800 V5, 6800 V5, 5300F V5, 5500F V5, 5600F V5, 5800F V5, and 6800F V5. Based on the CLI, this document describes how to use various commands classified by functionsand how to set the CLI and manage the storage system through these commands.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).



The reset command is used to reset the SES.






serial port mode

Usage Guidelines

  • When you run the command, the SES system will restart. It takes about 30 seconds for the SES system from a restart to proper running. If services are running during the interval, delivering I/Os into disks may be blocked and interrupted, thereby interrupting services.
  • Running this command is a highly risky operation. Execute this command with caution when there are ongoing services.


In standard disk enclosure devices, run the "reset" command to reset SES.

reset cmd successful. 

**                                                                    ** 
**                             SES System                             ** 
**                                                                    ** 

Boot version: R1-2016-02-20-B082 
enter the ThreadX kernel 

BoardType Gpio Value 0x1 
FruNum CRC Read 0xd442ae, Saved 0xd442ae, Magic 0xaced55aa 
Load Fan Register Funs! 
set ALL disk_phy ssc_type 0 under rate 0x8, enable 
Zone cfg iRv 0x0; Retry 1, valid is 1. 
str data init success. 
Sfp twi port init, board type is 33. 
Info: SASZONE init success, Zone enable state is 0. 
Buffering switch CRC Read 0xfec28155, Saved 0x3545ef9f, Magic 0xdb0398f, Switch 956330457 
Local State Now Is Slave !INFO: FrameStatus From 0xff to 0x1 

Firmware internal  Get fwdl type:0x3, flag:0x0 
build: B082, Release 04.08.02 
Flash active image build: B001, Release 32.85.00 
Flash active data(Init String)  build: B255, Release 55.55.15, Release Type 0f 
sas init ok 
It is not SAS card,no need to notify BMC 
Ses main start... 
BOARD:local eeprom self test result irv = 0x0 
Parse SysAlarmLed(1); SysPowerLed(1) by Uart 
Parse ucDevSetFrameSysAlarm=0 
Peer CustomRule_Mem, CRC 0x2ff983d4, FrameNumHex: 1

System Response


Updated: 2019-07-11

Document ID: EDOC1000181619

Views: 636249

Downloads: 256

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next