No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Advanced O&M Command Reference

OceanStor 5000, 5000F, 6000, and 6000F V5 Series V500R007

This document is applicable to OceanStor 5110 V5, 5110F V5, 5300 V5, 5500 V5, 5600 V5, 5800 V5, 6800 V5, 5300F V5, 5500F V5, 5600F V5, 5800F V5, and 6800F V5. Based on the CLI, this document describes how to use various commands classified by functionsand how to set the CLI and manage the storage system through these commands.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
xrb iomstat

xrb iomstat


The xrb iomstat command is used to collect information about IOPS during the specified period.


xrb iomstat -t time






Set a statistical period (unit: second).

The value is an integer between 1 and 120.


Diagnostic view

Usage Guidelines

  • To run the command, you must set a statistics period and the period cannot exceed 120 seconds.
  • Only after the statistical period runs out, you can perform the next collection operation.


Set the statistical period to 10 seconds and start collecting information.

admin:/diagnose>xrb iomstat -t 10 
pcie iom on success. 
Device(RDMA) not init. 
Please wait (10000)ms and check the result.

System Response


Updated: 2019-07-11

Document ID: EDOC1000181619

Views: 631114

Downloads: 252

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next