No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Advanced O&M Command Reference

OceanStor 5000, 5000F, 6000, and 6000F V5 Series V500R007

This document is applicable to OceanStor 5110 V5, 5110F V5, 5300 V5, 5500 V5, 5600 V5, 5800 V5, 6800 V5, 5300F V5, 5500F V5, 5600F V5, 5800F V5, and 6800F V5. Based on the CLI, this document describes how to use various commands classified by functionsand how to set the CLI and manage the storage system through these commands.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
change system config_msg_status

change system config_msg_status


The change system config_msg_status command is used to disable or enable engine configuration.


change system config_msg_status action=?






Indicates to enable or disable engine configuration.

The value can be "allow" or "forbid", where:

  • forbid:to disable engine configuration.
  • allow:to enable engine configuration.


Developer view

Usage Guidelines



To prevent the current engine from sending configuration messages, run the following command:

developer:/>change system config_msg_status action=forbid 
DANGER: You are going to perform system configuration control operations. If you disable engine configuration, configuration changes cannot be performed on the engine. If you enable engine configuration, configuration changes can be performed on the engine. 
Suggestion: Before you run this command, confirm that you have selected the engine you want to configure. 
Have you read danger alert message carefully?(y/n)y 
Are you sure you really want to perform the operation?(y/n)y 
Command executed successfully.

System Response


Updated: 2019-07-11

Document ID: EDOC1000181619

Views: 631172

Downloads: 252

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next