No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Advanced O&M Command Reference

OceanStor 5000, 5000F, 6000, and 6000F V5 Series V500R007

This document is applicable to OceanStor 5110 V5, 5110F V5, 5300 V5, 5500 V5, 5600 V5, 5800 V5, 6800 V5, 5300F V5, 5500F V5, 5600F V5, 5800F V5, and 6800F V5. Based on the CLI, this document describes how to use various commands classified by functionsand how to set the CLI and manage the storage system through these commands.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
change disk reset

change disk reset

Function

The change disk reset command is used to reset the specific hard disk.

Format

change disk reset disk_id=?

Parameters

Parameter

Description

Value

disk_id=?

ID of the hard disk.

To obtain the value, run "show disk general".

Views

Developer view, Engineer view

Usage Guidelines

Before executing this operation, please guarantee that the data on hard disk has been backed up.

Example

To reset the hard disk whose ID is "DAE000.0", run the following command. The command output varies depending on a specific product.

engineer:/>change disk reset disk_id=DAE000.0 
DENGER: You are about to restart the disk.  
This operation leads to data loss on the disk. If the disk domain where the disk resides is in the reconstruction or degradation state, this operation may cause reconstruction failure, service interruption, and data loss.  
Suggestion: Before performing this operation, ensure that data on the disk is backed up and check the status of the disk domain that houses the disk to avoid reconstruction failure, service interruption, and data loss.  
Have you read danger alert message carefully?(y/n)y 
Are you sure you really want to perform the operation?(y/n)y 
Command executed successfully.

System Response

None

Translation
Download
Updated: 2019-07-11

Document ID: EDOC1000181619

Views: 636916

Downloads: 256

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next