No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Advanced O&M Command Reference

OceanStor 5000, 5000F, 6000, and 6000F V5 Series V500R007

This document is applicable to OceanStor 5110 V5, 5110F V5, 5300 V5, 5500 V5, 5600 V5, 5800 V5, 6800 V5, 5300F V5, 5500F V5, 5600F V5, 5800F V5, and 6800F V5. Based on the CLI, this document describes how to use various commands classified by functionsand how to set the CLI and manage the storage system through these commands.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
change cluster port

change cluster port

Function

The change cluster port command is used to change the ID of the switch connected to the cluster IP scale-out ports.

Format

change cluster port port_id=? switch_port_id=?

Parameters

Parameter

Description

Value

port_id=?

ID of a port.

To obtain the value, run "show port general" and find "IP scale-out".

switch_id=?

ID of a switch.

Possible values are "switch0", "switch1", or "other", where:

  • "switch0": switch 0 on the network.
  • "switch1": switch 1 on the network.
  • "other": direct networking mode.

The default value is "other".

Views

Developer view

Usage Guidelines

  • Before running this command, ensure that the new port ID and switch ID are valid.
  • After running the "change cluster config_complete" command, run the "change cluster config_complete" command again to make the modification take effect.

Example

To switch the ID of the switch connected to port "CTE0.A.IOM1.P0" to "switch0", run the following command.

developer:/>change cluster port port_id=CTE0.A.IOM1.P0 switch_id=switch0 
DANGER: You are going to modify the Ethernet port information of the cluster. This operation may interrupt services or cause service exceptions. 
Suggestion: Before performing this operation, determine whether the modification is necessary. 
Have you read danger alert message carefully?(y/n)y 
Are you sure you really want to perform the operation?(y/n)y 
Command executed successfully.

System Response

None

Translation
Download
Updated: 2019-07-11

Document ID: EDOC1000181619

Views: 615676

Downloads: 244

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next