No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Advanced O&M Command Reference

OceanStor 5000, 5000F, 6000, and 6000F V5 Series V500R007

This document is applicable to OceanStor 5110 V5, 5110F V5, 5300 V5, 5500 V5, 5600 V5, 5800 V5, 6800 V5, 5300F V5, 5500F V5, 5600F V5, 5800F V5, and 6800F V5. Based on the CLI, this document describes how to use various commands classified by functionsand how to set the CLI and manage the storage system through these commands.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
cliset -d setpoweron

cliset -d setpoweron

Function

The cliset -d setpoweron command is used to power on the controller enclosure after the entire controller enclosure is powered off.

Format

cliset -d setpoweron parameter1

Parameters

Parameter

Description

Value

parameter1

Controller enclosure to be powered on.

The value is "1", indicating that the controller enclosure will be powered on.

Modes

serial port mode

Usage Guidelines

After the entire controller enclosure is powered off, you can run the cliset -d setpoweron 1 command to power on it.

Example

Entering "cliset -d setpoweron 1" on the serial port interface of the management module.

administrator@SMM_3U / $ cliset -d setpoweron 1 
administrator@SMM_3U / $ BOARD 0 state changed,cause is 0 .......................p0->p1 
set digital led value(888) Displayrule(1) Ok, SysPowerStatus:1, g_Opened:1. 
BOARD 0 state changed,cause is 0 .......................p1->p2 
[  375.798892] Begin to unregister USB platform device, Can't using USB now! 
[  377.142419] set irq67 to cpu:0x1 
[  377.195690] In ohci_hcd_hi1710_drv_probe 
[  377.199646] set irq68 to cpu:0x1 
BOARD 0 state changed,cause is 0 .......................p2->p3.

System Response

None

Translation
Download
Updated: 2019-07-11

Document ID: EDOC1000181619

Views: 633524

Downloads: 253

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next