No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Advanced O&M Command Reference

OceanStor 5000, 5000F, 6000, and 6000F V5 Series V500R007

This document is applicable to OceanStor 5110 V5, 5110F V5, 5300 V5, 5500 V5, 5600 V5, 5800 V5, 6800 V5, 5300F V5, 5500F V5, 5600F V5, 5800F V5, and 6800F V5. Based on the CLI, this document describes how to use various commands classified by functionsand how to set the CLI and manage the storage system through these commands.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
change hyper_metro_vstore_pair full_sync_cfg

change hyper_metro_vstore_pair full_sync_cfg


The change hyper_metro_vstore_pair full_sync_cfg command is used to fully synchronize configurations of a specific vStore pair.


change hyper_metro_vstore_pair full_sync_cfg pair_id=? partition_type=?






HyperMetro vStore pair ID.

To obtain the value, run the "show hyper_metro_vstore_pair general" command.


Type of a configuration synchronization partition.

  • "resource": Resource partition. Configurations in this partition include Resource user, Resource group, Identity mapping rule.
  • "nfs_v3": NFSv3 lock partition. The configurations in this partition includes information about NFSv3 client IP addresses.
  • "global": global partition. Configurations in this partition include CIFS service config, NFS service config, Resource user safe strategy.
  • "domain": domain controller partition. Configurations in this partition include AD domain config, NIS domain config, Ldap domain config, DNS config.


Developer view

Usage Guidelines

Run this command under the guidance of R&D engineers.


Fully synchronize configurations of a specific HyperMetro vStore pair, whose ID is "200bc79b99520000" and partition type is "NFS_V3".

developer:/>change hyper_metro_vstore_pair full_sync_cfg pair_id=200bc79b99520000 partition_type=nfs_v3 
WARNING: You are going to start configuration full synchronization. 
Once configuration synchronization is started, remote configuration will be overwritten by local configuration. After configuration synhronization, the configuration cannot be restored. 
Suggestion: Before performing this operation, ensure that the parameters are configured correctly to prevent configuration loss. 
Have you read warning message carefully?(y/n)y 
Are you sure you really want to perform the operation?(y/n)y 
Command executed successfully.

System Response


Updated: 2019-07-11

Document ID: EDOC1000181619

Views: 631875

Downloads: 252

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next