No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

FusionServer Pro XH321 V5 Server Node V100R005 Maintenance and Service Guide 07

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Installing the TPM

Installing the TPM

Procedure

  1. Power off the server node.

    For details, see Power-Off Procedure.

  2. Remove the server node.

    For details, see Removing an XH321 V5.

  3. Place the server node on the ESD workstation.
  4. Remove the air duct.

    For details, see Removing the Air Duct.

  5. Determine the position of the TPM.

    Figure 8-51 TPM position

  6. Take the spare part out of its ESD bag.
  7. Remove the PCIe card.

    For details, see Removing a PCIe Card.

  8. Install the M.2 SSD.

    For details, see Installing an M.2 SSD.

  9. Install the TPM.

    1. Align the TPM with the dowel pins on the side wall of the server node, and insert the TPM in the arrow direction.
      Figure 8-52 Installing a TPM
    2. Connect the cables to the TPM.

      For details, see TPM Cabling.

  10. Install the PCIe card.

    For details, see Installing a PCIe Card.

  11. Install the air duct.

    For details, see Installing the Air Duct.

  12. Install the server node.

    For details, see Installing an XH321 V5.

  13. Power on the server node.

    For details, see Power-On Procedure.

  14. Enable TPM.

    1. Access the BIOS interface.

      For details, see Huawei Server Purley Platform BIOS Parameter Reference.

    2. Select Security.

    3. Select TPM Operation and press Enter.

    4. Select Enable.

    5. Press F10.

      The system displays "Exit Saving changes?" dialog box is displayed.

    6. Select Yes.

      The settings are saved.

    7. Restart the server.

      The TPM settings take effect after the server is restarted.

Download
Updated: 2019-12-25

Document ID: EDOC1000183891

Views: 30894

Downloads: 110

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Share
Previous Next