No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

FusionServer Pro XH321 V5 Server Node V100R005 Maintenance and Service Guide 07

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Removing the Supercapacitor

Removing the Supercapacitor

Procedure

  1. Power off the server node.

    For details, see Power-Off Procedure.

  2. Remove the server node.

    For details, see Removing an XH321 V5.

  3. Place the server node on the ESD workstation.
  4. Determine the position of the supercapacitor.
  5. Remove the air duct for the supercapacitor.
  6. Remove the supercapacitor holder.

    1. Loosen the screws on the server node panel. See (1) in Figure 8-20.
    2. Remove the panel. See (2) in Figure 8-20.
    3. Loosen the screws that secure the supercapacitor holder and remove the supercapacitor holder. See (3) in Figure 8-20.
    Figure 8-20 Removing the supercapacitor holder

  7. Check whether the supercapacitor is configured with a TFM.

    • If yes, go to 8.
    • If no, go to 9.

  8. Remove the TFM.

    1. Remove the screw-in RAID controller card.

      For details, see Removing the Screw-in RAID Controller Card.

    2. Loosen the screws that secure the TFM. See (1) in Figure 8-21.
    3. Remove the TFM from the screw-in RAID controller card. See (2) in Figure 8-21.
    Figure 8-21 Removing a TFM
    1. Go to 10.

  9. Remove the cable between the supercapacitor and the RAID controller card.
  10. Remove the supercapacitor from the holder.

    Figure 8-22 Removing the supercapacitor

  11. Place the removed component in an ESD bag.
Download
Updated: 2019-12-25

Document ID: EDOC1000183891

Views: 31162

Downloads: 110

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Share
Previous Next