No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

FusionServer Pro XH321 V5 Server Node V100R005 Maintenance and Service Guide 07

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Removing the TPM

Removing the TPM

  • If the private key of the TPM interface board is used to encrypt data, back up the data before removing the TPM.

    If the data is not backed up, the encrypted data cannot be decrypted after the TPM is replaced.

  • If the TPM function has been set on the BIOS, record the settings before removing the TPM. After replacing the TPM, configure the related settings on the BIOS again.

    For details, see the Huawei Server Purley Platform BIOS Parameter Reference.

  • If a broken or disfigured screw is found on a TPM, take appropriate measures to protect data.

Procedure

  1. Power off the server node.

    For details, see Power-Off Procedure.

  2. Remove the server node.

    For details, see Removing an XH321 V5.

  3. Place the server node on the ESD workstation.
  4. Remove the air duct.

    For details, see Removing the Air Duct.

  5. Determine the position of the TPM.

    Figure 8-49 TPM position

  6. Remove the PCIe card.

    For details, see Removing a PCIe Card.

  7. Remove the TPM.

    1. Remove the cables from the TPM.

      For details, see TPM Cabling.

    2. Release the buckle on the TPM in the arrow direction, and push the TPM backwards until it cannot move forward. See (1) in Figure 8-50.
    3. Remove the TPM from the dowel pins on the side wall of the server node and take it out upwards. See (2) in Figure 8-50.
    Figure 8-50 Removing a TPM

  8. Remove the M.2 SSD.

    For details, see Removing an M.2 SSD.

  9. Place the removed component in an ESD bag.
Download
Updated: 2019-12-25

Document ID: EDOC1000183891

Views: 31171

Downloads: 110

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Share
Previous Next