No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

FusionServer Pro XH321 V5 Server Node V100R005 Maintenance and Service Guide 07

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Removing the PCIe Riser Module

Removing the PCIe Riser Module

Procedure

  1. Power off the server node.

    For details, see Power-Off Procedure.

  2. Remove the server node.

    For details, see Removing an XH321 V5.

  3. Place the server node on the ESD workstation.
  4. Determine the position of the PCIe riser module.
  5. Remove the PCIe riser modules.

    1. Use a Phillips screwdriver to loosen the screws on the cover of the server node. See (1) in Figure 8-61.
    2. Remove the cover from the server node in the arrow direction. See (2) in Figure 8-61.
    3. Use a Phillips screwdriver to loosen the screw that secures the PCIe riser module. See (3) in Figure 8-61.
    4. Lift the PCIe riser module in the arrow direction. See (4) in Figure 8-61.
      Figure 8-61 Removing the PCIe riser module

  6. Disconnect the cable between the PCIe card and the NC-SI port.

    For details, see PCIe Card Cabling.

    This operation is required only when the PCIe card is an SP380 NIC (BOM code: 02312JBD).

  7. Remove the PCIe card.

    For details, see Removing a PCIe Card.

  8. Place the removed PCIe riser module and PCIe card in different ESD bags.
  9. Install a filler panel.

    Perform this operation only when a PCIe riser module is not installed immediately.

    Figure 8-62 Installing a filler panel

Download
Updated: 2019-12-25

Document ID: EDOC1000183891

Views: 30935

Downloads: 110

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Share
Previous Next