No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


FusionServer Pro XH321 V5 Server Node V100R005 Maintenance and Service Guide 07

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Removing the Screw-in RAID Controller Card

Removing the Screw-in RAID Controller Card


  1. Power off the server node.

    For details, see Power-Off Procedure.

  2. Remove the server node.

    For details, see Removing an XH321 V5.

  3. Place the server node on the ESD workstation.
  4. Determine the position of the screw-in RAID controller card.

    Figure 8-16 Position of the screw-in RAID controller card

  5. Check whether a supercapacitor is configured.

    • If yes, go to 6.
    • If no, go to 7.

  6. Remove the supercapacitor.

    For details, see Removing the Supercapacitor.

  7. Remove the cable from the RAID controller card.

    For details, see Internal Cabling.

  8. Remove the RAID controller card.

    1. Loosen the screws that secure the RAID controller card. See (1) in Figure 8-17.
    2. Remove the RAID controller card from the connector on the mainboard. See (2) in Figure 8-17.
    Figure 8-17 Removing the screw-in RAID controller card

  9. Place the removed component in an ESD bag.
Updated: 2019-12-25

Document ID: EDOC1000183891

Views: 30633

Downloads: 110

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next