No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

FusionServer Pro XH321 V5 Server Node V100R005 Maintenance and Service Guide 07

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Ports

Ports

Port Positions

  • Ports on the front panel
    Figure 2-3 Ports on the front panel

    1

    Universal connector port

    2

    LOM port 1 (10GE optical port)

    3

    LOM port 2 (10GE optical port)

    4

    LOM port 3 (GE electrical port)

    5

    LOM port 4 (GE electrical port)

    6

    Management network port

  • Ports on the multi-port cable
    Figure 2-4 Multi-port cable

    1

    VGA port

    2

    Two USB ports

    3

    Serial port

    4

    One USB port

    5

    Multi-port connector

    -

    -

Port Description

Table 2-2 Ports on the front panel

Port

Type

Quantity

Description

Universal connector port

-

1

Used to connect a multi-port cable, which provides one DB-15 VGA port, three USB 2.0 ports, and one RJ45 serial port.

Management network port

RJ45

1

Used for server management.

NOTE:

The management network port is a GE port that supports 100 Mbit/s and 1000 Mbit/s auto-negotiation.

Table 2-3 LOM ports

Chip Model

Port Type

Rate Negotiation Mode

Supported Rates

Rates Not Supported

X722

10GE optical port

Auto-negotiation 10000 Mbit/s (full duplex)

10000M

10/100/1000M

GE electrical port

Auto-negotiation 1000 Mbit/s (full duplex)

1000M

10/100M

  • Use Intelligent Computing Compatibility Checker to obtain information about the cables and optical modules supported by the LOM ports.
  • The LOM ports do not support forced rates.
  • The electrical LOM ports cannot be connected to power over Ethernet (PoE) devices (such as a switch with PoE enabled). Connecting a LOM port to a PoE device may cause link communication failure or even damage the NIC.
  • The electrical LOM ports do not support SR-IOV.
  • Forcibly powering off a server will cause intermittent NC-SI disconnection and disable the Wake on LAN (WOL) function of the LOM ports. To restore the NC-SI connection, refresh the iBMC WebUI.
Download
Updated: 2019-12-25

Document ID: EDOC1000183891

Views: 30634

Downloads: 110

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Share
Previous Next