No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

WLAN V200R008C10 Typical Configuration Examples

Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Example for Configuring the Device as a PPPoE Client

Example for Configuring the Device as a PPPoE Client

Networking Requirements

As shown in Figure 5-11, the device functioning as the PPPoE client connects to the PPPoE server using GE0/0/0.

Users want the hosts to share an account. If the account is authenticated successfully on the PPPoE server, a PPPoE session is established. Service requirements are as follows:

  • The device establishes a PPPoE session with the PPPoE server using PPP authentication.

  • The device automatically attempts to create a dial-up connection again at intervals after the disconnection.
Figure 5-11 Networking diagram of the device functioning as the PPPoE client

Data Planning

Table 5-11 AC data planning

Item

Data

Uplink port

GE0/0/0

IP address allocation mode

PPPoE dialup

User name/Password

user1@system/huawei123

VLAN to which the PPPoE session is bound.

VLAN 100

NAT

Enabled

Configuration Roadmap

The configuration roadmap is as follows:
  1. Configure the PPPoE server.
  2. Configure the PPPoE client. Use the configuration wizard to configure the PPPoE dialup function and enable NAT to translate private IP addresses to public IP addresses.

Procedure

  1. Configure the PPPoE server.

    # Configure the authentication mode, IP address allocation mode, and IP address or IP address pool for PPPoE clients. For details about the configuration procedure, see the documentation of the PPPoE server.

  2. Configure the PPPoE client.
    1. Choose Wizard > Config Wizard. The Config Wizard page is displayed.
    2. Click Next.
    3. On the 2.Configure Internet Connection page, configure PPPoE dialup.

      NOTE:

      If you log in to the web platform using a PC whose Ethernet interface is being modified, do not delete the existing VLAN configuration on the interface to ensure that the PC can communicate with Fat APs. As shown in the following figure, GigabitEthernet0/0/0 is added to VLAN 1 by default and STAs communicate with the AP through this interface. You can use the default IP address of the AP to log in to the web platform. If you need to use the default IP address to log in to the web platform, do not delete VLAN 1.



    4. Click Finish.In the dialog box that is displayed, click OK.
  3. Verify the configuration.

    After the configuration is complete, a PPPoE dialup interface is automatically generated, through which hosts on the LAN can connect to the Internet using dialup. When wireless users attempt to connect to the public network, private IP addresses are translated into public IP addresses for communication.

Translation
Download
Updated: 2019-03-30

Document ID: EDOC1000184389

Views: 90381

Downloads: 458

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next