No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Maintenance Guide

TE30, TE40, TE50, TE60, and TX50 Videoconferencing Endpoint V600R006C10

This document guides the operator to maintain the device
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Using the Web Interface

Using the Web Interface

You can perform pan, tilt, and zoom (PTZ) control over a local or remote camera using the endpoint web interface.


You are familiar with the following buttons for camera control:

  • : Turns the camera upward, downward, leftward, and rightward.
  • : Turns the camera forward.
  • : Enlarges the image taken by a camera.
  • : Zooms in on a scene.
  • : Shrinks the image taken by a camera.
  • : Zooms out on a scene.
  • : Automatically adjusts the camera focus.


  1. Choose Device Control > Device Control.
  2. In the upper right corner of the Video Control page, select the camera you want to control, as shown in Figure 2-2 for the TE30 and Figure 2-1 for the TE40/TE50/TE60/TX50.

    Figure 2-1 Camera control
    Figure 2-2 Camera control
    • When your endpoint is not in a conference, you can select only Local camera.
    • When your endpoint is in a conference, you can select Local camera or Remote camera. By default, Local camera is selected.

    When Monitor video is enabled, the video delivered from the camera under control is displayed on the Video Control page. You can then view the camera output while you control the camera.

  3. Click the buttons shown in Figure 2-1 or Figure 2-2 to control cameras.

When the desired video is displayed on the monitor, you can save the camera settings as a preset so you can easily switch to the preset in the future. For details about how to set a camera preset, see Using the Web Interface.

Updated: 2019-01-31

Document ID: EDOC1000184611

Views: 30420

Downloads: 162

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next