No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Maintenance Guide

TE30, TE40, TE50, TE60, and TX50 Videoconferencing Endpoint V600R006C10

This document guides the operator to maintain the device
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Using HTTPS for SiteCalls

Using HTTPS for SiteCalls

The endpoint uses Hypertext Transfer Protocol Secure (HTTPS) mode to upload the multipoint conference information by default and supports Transmission Control Protocol (TCP) mode when a multipoint conference is initiated. If HTTPS mode is disabled, the endpoint uses the insecure TCP mode. You are advised to use HTTPS mode for better communication security.

If HTTPS mode is enabled, you are advised to enable Multipoint conference authentication.

Following are methods to enable HTTPS mode and Multipoint conference authentication:

  • On the remote control UI, choose Advanced > Settings > Network > IP > H.323, and select HTTPS mode and Multipoint conference authentication.
  • On the web interface, choose System Settings > Network > H.323/SIP Settings, and set HTTPS mode and Multipoint conference authentication to Enable.
Updated: 2019-01-31

Document ID: EDOC1000184611

Views: 30540

Downloads: 162

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next