No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

OceanStor 9000 V300R006C20 Hardware Installation Guide 05

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Attaching Labels

Attaching Labels

This section describes different methods of attaching labels.

Attaching PGND and Power Cable Labels

First attach a label to the sign plate of the cable tie (only to one side). Then, bind the cable tie to the position 20 mm from the connector, as shown in Figure 15-182.

NOTE:
  • Attach the label to the rectangular recess on the sign plate. Which side the label is attached to is not specified (determined by a customer) but must be unified.
  • The distance between a label and a connector can be adjusted but must be unified.
  • When cables are routed vertically, their labels face right side; when routed horizontally, labels face upwards.
Figure 15-182  Binding of a sign plate to a power cable

Attaching Labels to Power Cables Inside a Cabinet

Attach the label to the place 20 mm from the power cable connector, as shown in Figure 15-183.

NOTE:
  • Do not attach a label to a bending part or a place where the label may affect cable installation.
  • The distance between a label and a connector can be adjusted but must be unified.
  • When cables are routed vertically, their labels face right side; when routed horizontally, labels face upwards.
Figure 15-183  Attaching a label to an intra-cabinet power cable

Attaching Signal Cable Labels

Attach the label to the place 20 mm from the signal cable connector and fold the label, as shown in Figure 15-184 and Figure 15-185.

NOTE:
  • Do not attach a label to a bending part or a place where the label may affect cable installation.
  • The distance between a label and a connector can be adjusted but must be unified.
  • When cables are routed vertically, their labels face right side; when routed horizontally, labels face upwards.
Figure 15-184  Attaching a label to a signal cable (1)

Figure 15-185  Attaching a label to a signal cable (2)

Translation
Download
Updated: 2019-03-26

Document ID: EDOC1000185366

Views: 46557

Downloads: 166

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next