No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

OceanStor 9000 V300R006C20 Hardware Installation Guide 05

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Obtaining Tools and Meters

Obtaining Tools and Meters

Before installing devices, ensure that all required installation tools and meters are ready.

Table 3-2 and Table 3-3 list the tools and meters required for the installation.

NOTE:
  • The tools and meters described in this topic are examples only. The actual tools and meters may be different.
  • The meters must be qualified with the measurement calibration for proper usage.
Table 3-2  Required tools

No.

Name

Tool

Usage

1

Marker



Used to make marks

2

Phillips screwdriver (M3 to M6)



Used to fasten small screws and bolts, instead of nuts. The Phillips screwdriver has a cross-shaped head and provides a small moment of fastening force.

3

Flat-head screwdriver



Used to fasten small screws and bolts, instead of nuts. The flat-head screwdriver has a line-shaped head and provides a small moment of fastening force.

4

Diagonal pliers



Used to cut insulation tubes and cable ties

5

Crimping tool



Used to crimp network cables

6

Utility knife



Used to cut paper

7

Floating mounting bar



Used to install or remove floating nuts

8

ESD clothes



Used to prevent the electrostatic discharge (ESD) from damaging a board or other electrostatic sensitive devices (ESSDs)

9

ESD gloves



Used to prevent ESD from damaging a board or other ESSDs

10

ESD wrist strap



Used to prevent ESD when you touch or operate a device or component

Table 3-3  Required meters

No.

Name

Tool

Usage

1

Multimeter

Used to measure the insulation of a cabinet, connection of a cable, and electric performance specifications of a device, such as voltage, current, and resistance

2

Network cable tester

Used to test whether a network cable is connected and check the connection sequence in a network cable

Translation
Download
Updated: 2019-03-26

Document ID: EDOC1000185366

Views: 43553

Downloads: 164

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next