No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

OceanStor 9000 V300R006C20 Hardware Installation Guide 05

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Removing the Filler Panel from the Cabinet

Removing the Filler Panel from the Cabinet

If filler panels are installed on the planned device installation position of the cabinet, remove the filler panels before installing the device.

Prerequisites

Filler panels have been located in the cabinet.

Procedure

  1. Determine the filler panels to be removed according to the position of the chassis in the cabinet.
  2. Hold the snap-in connectors at both sides of a filler panel to be removed, press the snap-in connectors with your middle fingers, and pull out the filler panel with proper force, as shown in Figure 8-1.

    Figure 8-1  Removing a filler panel from the cabinet

Translation
Download
Updated: 2019-03-26

Document ID: EDOC1000185366

Views: 44072

Downloads: 164

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next