No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


OceanStor 9000 V300R006C20 Hardware Installation Guide 05

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Unloading Equipment

Unloading Equipment

After the equipment reaches the destination, unload it using manual pallet trucks, electrical pallet trucks, or cranes.

Table 4-3 lists the unloading ways suitable for different types of vehicles.
Table 4-3  Unloading ways suitable for different types of vehicles

Vehicle Type

Recommended Unloading Way

Schematic Drawing

With a tailboard

Using a manual pallet truck

Figure 4-3

Without a tailboard

Using an electrical pallet truck

Figure 4-4

With a crane arm

Using the crane arm of the vehicle

Figure 4-5

Using a Manual Pallet Truck

Figure 4-3 shows how to unload equipment from the vehicle with a tailboard using a manual pallet truck.
Figure 4-3  Unloading equipment using a manual pallet truck

Using an Electrical Pallet Truck

Figure 4-4 shows how to unload equipment from the vehicle without a tailboard using an electrical pallet truck.
Figure 4-4  Unloading equipment using an electrical pallet truck

Using a Crane Arm

Do not stand under the crane arm or lifted equipment when the crane is working.

  • Do not suddenly stop or start the crane after the crane has lifted equipment or when the crane arm is spinning.
  • Ensure that the crane lifts equipment steadily and that the equipment is not swaying.
  • When the crane is lifting equipment, ensure that the angle between any two hoist cables is less than 90 degrees.
Figure 4-5 shows how to unload equipment using the crane arm of a vehicle.
Figure 4-5  Unloading equipment using the crane arm of a vehicle

Updated: 2019-03-26

Document ID: EDOC1000185366

Views: 46248

Downloads: 166

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next