Removing the Daughter Board
Perform this procedure only when four CPUs are used.
Procedure
- Power off the server.
For details, see Power-Off Procedure.
- Remove the power cables from the PSUs.
For details, see Removing PSU Cables.
- Remove the server.
For details, see Removing a 2488H V5.
- Place the server on the ESD workstation.
- Remove the chassis cover.
For details, see Removing the Chassis Cover.
- Check whether a full-length PCIe riser module is configured.
- Remove the full-length PCIe riser module.
For details, see Removing a PCIe Riser Module.
- Determine the position of the daughter board.
- Remove the daughter board.
- Pull the handle in the arrow direction as far as it will go and ensure that the daughter board is disconnected from the connector. See (1) and (2) in Figure 8-179.
- Remove the daughter board from the chassis. See (3) in Figure 8-179.
- Place the removed component in an ESD bag.
Place only one component in an ESD bag.