Removing a Memory Module
The procedures for removing the DCPMMs and DDR4 memory modules are the same. The following uses a DDR4 memory module as an example.
Procedure
- Power off the server.
For details, see Power-Off Procedure.
- Remove the power cables from the PSUs.
For details, see Removing PSU Cables.
- Remove the server.
For details, see Removing a 2488H V5.
- Place the server on the ESD workstation.
- Remove the chassis cover.
For details, see Removing the Chassis Cover.
- Determine the position of the memory module.Figure 8-104 Memory slots on the mainboardFigure 8-105 Memory slots on the daughter board
- Remove the air duct or daughter board.
Perform this step only when the memory module is installed on the mainboard.
- If the server has two processors, remove the air duct.
- If the server has four processors, remove the daughter board.
For details, see Removing the Air Duct or Removing the Daughter Board.
- Remove the memory module.
- Open the memory module ejectors on the memory slot. See (1) in Figure 8-106.
- Remove the memory module from the slot. See (2) in Figure 8-106.
- Place the removed memory module in a memory box.
- Install memory modules.
Perform this operation only when a memory module is not installed immediately.