Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Removing a PCIe Riser Module
Procedure
- Power off the server.
For details, see Power-Off Procedure.
- Remove the power cables from the PSUs.
For details, see Removing PSU Cables.
- Remove the server.
For details, see Removing a 2488H V5.
- Place the server on the ESD workstation.
- Remove the chassis cover.
For details, see Removing the Chassis Cover.
- Determine the position of the PCIe riser module.
- Remove the PCIe riser module.Figure 8-179 Removing the PCIe riser module
- Remove the PCIe card from the PCIe riser module.
For details, see Removing a PCIe Card from the Riser Card.
- Place the removed PCIe riser module and PCIe card in different ESD bags.
Place only one component in an ESD bag.
- Install a filler panel.
Perform this operation only when a PCIe riser module is not installed immediately.
Figure 8-180 Installing a filler panel
