No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - Device Management

CloudEngine 12800 and 12800E V200R003C00

This document describes the configurations of Device Management, including device status query, hardware management, Information Center Configuration, NTP, Synchronous Ethernet Configuration, Fault Management Configuration, Energy-Saving Management Configuration, Performance Management Configuration, Maintenance Assistant Configuration, and OPS Configuration.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring an Energy-Saving Mode

Configuring an Energy-Saving Mode


The device supports the following energy-saving modes:
  • User-defined mode: allows the energy-saving mode to be configured as service requires.

  • Standard mode: is supported by the device by default and supports intelligent fan speed adjustment.

  • Basic mode: uses technologies supported by the standard mode and allows the device to power off redundant power modules based on rated power consumption.

  • Deep mode: uses technologies supported by the basic mode and allows the device to power off redundant SFUs based on link bandwidth usage between LPUs and SFUs.


The user-defined mode is not supported by the device and the other three modes can be used.


  1. Run system-view

    The system view is displayed.

  2. Run set device power manage mode mode

    An energy-saving mode is configured for the device.

    By default, the standard energy-saving mode is used.

  3. Run commit

    The configuration is committed.

Verifying the Configuration

  • Run the display device power system command to check the energy-saving mode of the device.

Updated: 2019-05-05

Document ID: EDOC1100004193

Views: 71135

Downloads: 26

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next