No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - Device Management

CloudEngine 12800 and 12800E V200R003C00

This document describes the configurations of Device Management, including device status query, hardware management, Information Center Configuration, NTP, Synchronous Ethernet Configuration, Fault Management Configuration, Energy-Saving Management Configuration, Performance Management Configuration, Maintenance Assistant Configuration, and OPS Configuration.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring EEDB Resource Specifications for RIOT

Configuring EEDB Resource Specifications for RIOT


EEDB is a type of chip forwarding resources, which must be allocated when forwarding services are configured. By default, EEDB resources of two banks are reserved for RIOT. If no RIOT services are deployed on the switch, disable RIOT from occupying EEDB resources so that other services can use EEDB resources reserved for RIOT. This operation can increase specifications of other services. For example, ARP specifications of a card can be increased from 80,000 to 88,000.

Currently, only Layer 3 VXLAN services require RIOT to use EEDB resources. After RIOT is disabled from occupying EEDB resources, Layer 3 VXLAN is not supported.


CE12800E does not support this function.


  1. Run system-view

    The system view is displayed.

  2. Run ip routing riot disable

    RIOT is disabled from occupying EEDB resources.

    By default, RIOT can occupy EEDB resources of two banks.


    The command configuration takes effect after the switch is restarted.

    This function can be configured only when the card interoperability mode is enhanced mode. To check and configure the card interoperability mode, run the display forward capability and set forward capability enhanced commands.

  3. Run commit

    The configuration is committed.

Updated: 2019-05-05

Document ID: EDOC1100004193

Views: 70643

Downloads: 26

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next