No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - Device Management

CloudEngine 12800 and 12800E V200R003C00

This document describes the configurations of Device Management, including device status query, hardware management, Information Center Configuration, NTP, Synchronous Ethernet Configuration, Fault Management Configuration, Energy-Saving Management Configuration, Performance Management Configuration, Maintenance Assistant Configuration, and OPS Configuration.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the Device to Output Traps to an SNMP Agent

Configuring the Device to Output Traps to an SNMP Agent


When an exception or a fault occurs on the device, the network administrator needs to learn the device running status. You can configure the device to output traps to an NMS server so that the network administrator can monitor the device in real time and locate faults immediately. Before configuring the device to output traps to an NMS server, configure the device to output traps to an SNMP agent. Then the SNMP agent sends traps to the NMS server.


  1. Run system-view

    The system view is displayed.

  2. Run info-center snmp channel { channel-number | channel-name }

    The channel used by the device to output traps to an SNMP agent is specified.

    By default, the device uses channel 5 to output traps to an SNMP agent.

  3. Run info-center source { module-name | default } channel { channel-number | channel-name } trap { state { off | on } | level severity } *

    A rule for outputting traps to a channel is set.

    By default, channel 5 is enabled to output traps and the lowest severity is debugging.

  4. Run snmp-agent

    The SNMP agent function is enabled.

    By default, the SNMP agent function is disabled.

    The SNMP agent can work properly and receive traps only when the SNMP agent function is enabled.

    For details on how to configure the SNMP agent, see SNMP Configuration in the CloudEngine 12800 and 12800E Series Switches Configuration Guide - Network Management and Monitoring.

  5. Run commit

    The configuration is committed.

Updated: 2019-05-05

Document ID: EDOC1100004193

Views: 71200

Downloads: 26

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next