No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - Device Management

CloudEngine 12800 and 12800E V200R003C00

This document describes the configurations of Device Management, including device status query, hardware management, Information Center Configuration, NTP, Synchronous Ethernet Configuration, Fault Management Configuration, Energy-Saving Management Configuration, Performance Management Configuration, Maintenance Assistant Configuration, and OPS Configuration.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the Device to Output Traps to the Trap Buffer

Configuring the Device to Output Traps to the Trap Buffer


To view traps in the trap buffer, configure the device to output traps to the trap buffer.


  1. Run system-view

    The system view is displayed.

  2. Run info-center trapbuffer

    The device is enabled to output traps to the trap buffer.

    By default, the device is enabled to output traps to the trap buffer.

  3. Run info-center trapbuffer channel { channel-number | channel-name } [ size trapbuffer-size ]

    The channel used by the device to output traps to the trap buffer is specified.

    By default, the device uses channel 3 to output traps to the trap buffer.

  4. Run info-center source { module-name | default } channel { channel-number | channel-name } trap { state { off | on } | level severity } *

    A rule for outputting traps to a channel is set.

    By default, channel 3 is enabled to output traps and the lowest severity is debugging.

  5. (Optional) Run info-center trapbuffer size trapbuffer-size [ channel { channel-number | channel-name } ]

    The maximum number of traps in the trap buffer is set.

    By default, the trap buffer can store a maximum of 256 traps.

  6. Run commit

    The configuration is committed.

Updated: 2019-05-05

Document ID: EDOC1100004193

Views: 69929

Downloads: 26

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next