No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - VXLAN

CloudEngine 12800 and 12800E V200R003C00

This document describes the configurations of VXLAN.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Collecting and Checking VXLAN Packet Statistics

Collecting and Checking VXLAN Packet Statistics

NOTE:

If a message indicating that the service fails to be delivered because of insufficient resources is displayed on the switch when this function is configured, you are advised to configure MQC-based traffic statistics collection.

Procedure

  • Enable BD-based packet statistics collection.
    1. Run system-view

      The system view is displayed.

    2. Run bridge-domain bd-id

      A BD is created, and the BD view is displayed.

      By default, no BD is created.

    3. Run statistics enable

      Traffic statistics collection is enabled for the BD.

      By default, traffic statistics collection is disabled in BDs.

    4. Run commit

      The configuration is committed.

  • Enable VXLAN-based packet statistics collection.
    1. Run system-view

      The system view is displayed.

    2. Run interface nve nve-number

      An NVE interface is created, and the NVE interface view is displayed.

      By default, no NVE interface is created.

    3. Run vxlan statistics peer peer-ip-address [ vni vni-id ] enable

      Or run vxlan statistics peer peer-ipv6-address [ vni vni-id ] enable

      Traffic statistics collection is enabled for the VXLAN tunnel.

      By default, statistics collection of VXLAN tunnel packets is disabled.

      NOTE:

      The functions of collecting packet statistics based on the VXLAN tunnel and VNI and based on the VXLAN tunnel only are mutually exclusive. For example, the vxlan statistics peer 10.1.1.1 vni 10000 enable and vxlan statistics peer 10.1.1.1 enable commands cannot be configured simultaneously.

    4. Run commit

      The configuration is committed.

Follow-up Procedure

  • Run the display bridge-domain bd-id statistics command to check traffic statistics of a BD.

  • Run the display vxlan statistics source source-ip-address peer peer-ip-address [ vni vni-id ] or display vxlan statistics source source-ipv6-address peer peer-ipv6-address [ vni vni-id ] command to view VXLAN tunnel packet statistics.

Translation
Download
Updated: 2019-05-05

Document ID: EDOC1100004207

Views: 25091

Downloads: 65

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next