No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - DCN and Server Management

CloudEngine 8800, 7800, 6800, and 5800 V200R003C00

This document describes the configurations of Trill, FCoE, DCB, and NLB Server Cluster Association.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring a Role for an Interface

Configuring a Role for an Interface

Context

On a traditional Fiber Channel (FC) network, initiators and targets of storage area network (SAN) traffic are explicitly specified. Because traditional Ethernet does not define the traffic transmission direction, roles of FIP snooping bridge (FSB) interfaces must be defined during network planning.
Figure 2-33 Roles of FSB interfaces
Roles of FSB interfaces are as follows:
  • VNP_Port: FCoE switch port connected to an FCF
  • ENode_Facing port: FCoE switch port connected to a server
NOTE:

Before configuring a role for an interface, add the interface to an FCoE VLAN.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The Ethernet interface view is displayed.

  3. Run port link-type { trunk | hybrid }

    The link type of the interface is configured.

    By default, the link type of an interface is access.

  4. Run port trunk allow-pass vlan { { vlan-id1 [ to vlan-id2 ] }&<1-10> | all }

    Or run port hybrid tagged vlan { { vlan-id1 [ to vlan-id2 ] }&<1-10> | all }

    The interface is added to an FCoE VLAN.

  5. Run fcoe role vnp

    The interface is configured as a VNP_Port.

    By default, an Ethernet interface is an ENode_Facing port.

  6. Run commit

    The configuration is committed.

Translation
Download
Updated: 2019-05-08

Document ID: EDOC1100004349

Views: 30384

Downloads: 120

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next