No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - DCN and Server Management

CloudEngine 8800, 7800, 6800, and 5800 V200R003C00

This document describes the configurations of Trill, FCoE, DCB, and NLB Server Cluster Association.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring FIP Snooping on the FSB

Configuring FIP Snooping on the FSB

Pre-configuration Tasks

Fibre channel Initialization Protocol (FIP) snooping enables the FIP snooping bridge (FSB) to obtain Fibre Channel over Ethernet (FCoE) virtual link information by listening on FIP packets. This function is used to control FCoE virtual link setup and prevent malicious attacks.

Before configuring FIP snooping, complete the following task:
  • Configure a link layer protocol so that interfaces at both ends of a link are Up.

Configuration Process

Figure 2-32 FSB configuration flowchart
Updated: 2019-05-08

Document ID: EDOC1100004349

Views: 32377

Downloads: 120

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next