No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Ethernet Switching

CloudEngine 8800, 7800, 6800, and 5800 V200R003C00

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, MUX VLAN, Voice VLAN, VLAN mapping, QinQ, GVRP, VCMP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, and Layer 2 protocol transparent transmission.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Changing to the MSTP Mode

Changing to the MSTP Mode

Context

If an interface on an MSTP-enabled device is connected to an STP-enabled device, the interface changes to the STP-compatible mode.

If the STP-enabled device is changed to MSTP mode, or if it is powered off or disconnected from the MSTP-enabled device, the interface cannot automatically change to MSTP mode. In this case, use the stp mcheck command to configure the interface to change to the MSTP mode.

Procedure

  • Changing to the MSTP mode in the interface view
    1. Run system-view

      The system view is displayed.

    2. Run interface interface-type interface-number

      The view of the Ethernet interface that participates in spanning tree calculation is displayed.

    3. Run stp mcheck

      The device is changed to the MSTP mode.

    4. Run commit

      The configuration is committed.

  • Changing to the MSTP mode in the system view
    1. Run system-view

      The system view is displayed.

    2. (Optional) Run stp process process-id

      The MSTP process view is displayed.

      NOTE:

      Skip this step if you perform configurations in the MSTP process 0.

    3. Run stp mcheck

      The device is changed to the MSTP mode.

    4. Run commit

      The configuration is committed.

Translation
Download
Updated: 2019-05-08

Document ID: EDOC1100004351

Views: 93779

Downloads: 276

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next