No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Ethernet Switching

CloudEngine 8800, 7800, 6800, and 5800 V200R003C00

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, MUX VLAN, Voice VLAN, VLAN mapping, QinQ, GVRP, VCMP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Summary of ERPS Configuration Tasks

Summary of ERPS Configuration Tasks

After a single ERPS ring or intersecting ERPS ring is configured, a specified port can be blocked to remove loops. Table 12-5 describes the ERPS configuration tasks.

Table 12-5 ERPS configuration tasks

Scenario

Description

Task

Configure ERPS single-ring networking

You can configure ERPS single-ring networking when there is only one ring in the network topology.

Configuring ERPSv1

Configure ERPS intersecting-ring networking

You can configure ERPS intersecting-ring networking when there are two or more rings in the network topology and many common nodes between two rings.

Configuring ERPSv2

Translation
Download
Updated: 2019-05-08

Document ID: EDOC1100004351

Views: 125585

Downloads: 295

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next