No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Ethernet Switching

CloudEngine 8800, 7800, 6800, and 5800 V200R003C00

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, MUX VLAN, Voice VLAN, VLAN mapping, QinQ, GVRP, VCMP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, and Layer 2 protocol transparent transmission.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Verifying the Configuration of Assigning a LAN to VLANs

Verifying the Configuration of Assigning a LAN to VLANs

Procedure

  • Run the display vlan reserved command to view information about reserved VLANs.
  • Run the display port vlan [ interface-type interface-number ] [ active ] command to view information about interfaces of the VLAN.
  • Run the display vlan command to check information about all VLANs or a specified VLAN.
  • Run the display mac-vlan { mac-address { all | mac-address } | vlan vlan-id } command to check information about VLANs configured based on MAC addresses.
  • Run the display ip-subnet-vlan vlan { all | vlan-id1 [ to vlan-id2 ] } command to check information about IP subnet associated with VLANs.
  • Run the display protocol-vlan vlan { all | vlan-id1 [ to vlan-id2 ] } command to check the types and indexes of the protocols associated with VLANs.
  • Run the display protocol-vlan interface { all | interface-type interface-number } command to check information about VLANs configured based on protocols associated with ports.
Translation
Download
Updated: 2019-05-08

Document ID: EDOC1100004351

Views: 80967

Downloads: 274

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next