No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Ethernet Switching

CloudEngine 8800, 7800, 6800, and 5800 V200R003C00

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, MUX VLAN, Voice VLAN, VLAN mapping, QinQ, GVRP, VCMP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring a Priority for a Device

(Optional) Configuring a Priority for a Device

Context

An STP/RSTP network can have only one root bridge, which is the logical center of the spanning tree. The root bridge should be a high-performance device deployed at a high network layer. To ensure a certain device is selected as the root bridge, you can set a high priority for the device.

Set low priorities for devices that are not suitable as the root bridge, such as low-performance devices at lower network layers.

A smaller priority value indicates a higher priority of a device.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run stp priority priority

    A priority is set for the device.

    The default priority value of a device is 32768.

    If the stp root primary or stp root secondary command has been executed to configure the device as the root bridge or secondary root bridge, run the undo stp root command to disable the root bridge or secondary root bridge function and then run the stp priority priority command to set a priority.

  3. Run commit

    The configuration is committed.

Translation
Download
Updated: 2019-05-08

Document ID: EDOC1100004351

Views: 125977

Downloads: 295

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next