No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Ethernet Switching

CloudEngine 8800, 7800, 6800, and 5800 V200R003C00

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, MUX VLAN, Voice VLAN, VLAN mapping, QinQ, GVRP, VCMP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Setting the Number of LAGs

(Optional) Setting the Number of LAGs

Context

Typically, the number of LAGs supported by a switch is fixed. However, you can run the assign forward eth-trunk mode command to flexibly set the number of LAGs supported by a switch, implementing flexible networking and meeting diversified service requirements.

NOTE:

The number of LAGs supported by the CE5810EI and CE6880EI is fixed. The CE5810EI and CE6880EI do not support a variable number of LAGs.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run assign forward eth-trunk mode { 64 | 128 | 256 | 512 | 1024 }

    The number of LAGs supported by the device is set.

    For CE6870EI and CE6875EI, the number of LAGs supported by the device can be set using the assign forward eth-trunk mode { 256 | 512 | 1024 } command.

    By default, the CE6870EI and CE6875EI support 512 LAGs; other models support 128 LAGs.

    NOTE:

    After the assign forward eth-trunk mode command is used to change the number of LAGs supported by the device, restart the device to make the configuration take effect.

  3. Run commit

    The configuration is committed.

Translation
Download
Updated: 2019-05-08

Document ID: EDOC1100004351

Views: 116205

Downloads: 288

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next