No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - Ethernet Switching

CloudEngine 8800, 7800, 6800, and 5800 V200R003C00

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, MUX VLAN, Voice VLAN, VLAN mapping, QinQ, GVRP, VCMP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, and Layer 2 protocol transparent transmission.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Clearing M-LAG Historical Fault Event Information

Clearing M-LAG Historical Fault Event Information


Before you check causes of M-LAG faults within a certain period, clear the existing historical fault event information on the device.

The historical fault event information about M-LAG faults cannot be restored after being cleared. Confirm your operation before clearing the historical fault event information.


  • Run the reset m-lag troubleshooting history command in the user view to clear historical fault event information about M-LAG faults.
Updated: 2019-05-08

Document ID: EDOC1100004351

Views: 159752

Downloads: 326

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next