No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - Ethernet Switching

CloudEngine 8800, 7800, 6800, and 5800 V200R003C00

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, MUX VLAN, Voice VLAN, VLAN mapping, QinQ, GVRP, VCMP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring the Weight of Load Balancing for a Member Interface

(Optional) Configuring the Weight of Load Balancing for a Member Interface


On an Eth-Trunk interface, you can load balance traffic among member interfaces according to the weights configured for the member interfaces.

The higher the weight of a member interface, the heavier the load over the member link. Therefore, you can configure a higher weight for a member interface so that the member link can carry a heavier load.


  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The Eth-Trunk member interface view is displayed.

  3. Run distribute-weight weight-value

    The load balancing weight is configured for the Eth-Trunk member interface.

    The default weight of an Eth-Trunk member interface is 1.

    The total weight of member interfaces in an Eth-Trunk cannot exceed the maximum number of member interfaces allowed.

  4. Run commit

    The configuration is committed.

Updated: 2019-05-08

Document ID: EDOC1100004351

Views: 126061

Downloads: 295

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next