No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Ethernet Switching

CloudEngine 8800, 7800, 6800, and 5800 V200R003C00

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, MUX VLAN, Voice VLAN, VLAN mapping, QinQ, GVRP, VCMP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
The Physical Status of the Member Interface Is Up But the Link Protocol Status Is Down Because Link Aggregation Is Not Configured on the Remote End

The Physical Status of the Member Interface Is Up But the Link Protocol Status Is Down Because Link Aggregation Is Not Configured on the Remote End

Fault Description

SwitchA is configured with link aggregation, but SwitchB is not configured with link aggregation. As a result, the physical status of the member interface on SwitchA is Up but the link protocol status is Down.

Procedure

  1. Run the display this command on 10GE1/0/1, 10GE1/0/2, and 10GE1/0/3 of SwitchB. The three interfaces do no join the Eth-Trunk.

    If interfaces join the Eth-Trunk, you can view the following configuration in the command output.

    #                                                                                                                                   
    interface 10GE1/0/1                                                                                                      
     eth-trunk 1                                                                                                                        
    #

  2. On SwitchB, configure the same link aggregation mode as SwitchA. For details, see Configuring Link Aggregation in Manual Load Balancing Mode or Configuring Link Aggregation in LACP Mode.
Translation
Download
Updated: 2019-05-08

Document ID: EDOC1100004351

Views: 117167

Downloads: 290

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next