No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - Ethernet Switching

CloudEngine 8800, 7800, 6800, and 5800 V200R003C00

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, MUX VLAN, Voice VLAN, VLAN mapping, QinQ, GVRP, VCMP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Traffic Forwarding Fails in an ERPS Ring

Traffic Forwarding Fails in an ERPS Ring

Fault Description

After ERPS is configured, user traffic cannot be properly forwarded due to abnormal ERPS ring status.


  1. Check the port roles in the ERPS ring and status of each device in the ring.

    In an ERPS ring, there should be only one RPL owner port. Other ports are common ports or RPL neighbor ports.

    Run the display erps [ ring ring-id ] verbose command in any view to check whether the value of Ring State is Idle. (Perform this operation on each device in the ERPS ring.)

    If the ERPS ring is incomplete or its status is abnormal, perform the following operations:
    1. Verify that all nodes in the ERPS ring are added to the ERPS ring.
    2. Check whether the ERPS ring configuration including the ERPS version number and major ring/sub-ring on devices in the ERPS ring are the same.
    3. Verify that port roles, control VLANs, and protected instances are correctly configured on all nodes in the ERPS ring.
    4. Verify that ports can allow packets of the specified VLANs to pass.

Updated: 2019-05-08

Document ID: EDOC1100004351

Views: 125271

Downloads: 295

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next