No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - Ethernet Switching

CloudEngine 8800, 7800, 6800, and 5800 V200R003C00

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, MUX VLAN, Voice VLAN, VLAN mapping, QinQ, GVRP, VCMP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring STP Timers

Configuring STP Timers


There are three timers used in spanning tree calculation: Forward Delay, Hello Time, and Max Age. These timers can be configured to affect STP convergence. However, you are not advised to directly change these timers. Instead, it is recommended that you set the network diameter so that the spanning tree protocol automatically adjusts these timers in accordance with the network scale.

The following timers are used in spanning tree calculation:
  • Forward Delay: specifies the delay before a state transition. After the topology of a ring network changes, it takes some time for the new configuration BPDU to spread throughout the entire network. As a result, the original blocked port may be unblocked before a new port is blocked, creating a loop on the network. The purpose of the Forward Delay timer is to prevent loops. When the topology changes, all ports will be temporarily blocked during the Forward Delay.
  • Hello Time: specifies the interval at which hello packets are sent. A device sends configuration BPDUs at the specified interval to detect link failures. If the switching device does not receive any BPDUs within an interval of Hello Time x 3 x Timer Factor, the device recalculates the spanning tree.
  • Max Age: determines whether a BPDU has timed out. A device determines that a received configuration BPDU times out when the Max Age expires.

Devices on a ring network must use the same values of Forward Delay, Hello Time, and Max Age.

To prevent frequent network flapping, make sure that the Hello Time, Forward Delay, and Max Age timer values conform to the following formulas:

  • 2 x (Forward Delay - 1.0 second) ≥ Max Age

  • Max Age ≥ 2 x (Hello Time + 1.0 second)


  1. Run system-view

    The system view is displayed.

  2. Set the Forward Delay, Hello Time, and Max Age timers.
    1. Run stp timer forward-delay forward-delay

      The Forward Delay timer is set for the device.

      By default, the Forward Delay timer is 1500 centiseconds (15 seconds).

    2. Run stp timer hello hello-time

      The Hello Time is set for the device.

      By default, the Hello Time is 200 centiseconds (2 seconds).

    3. Run stp timer max-age max-age

      The Max Age timer is set for the device.

      By default, the Max Age timer is 2000 centiseconds (20 seconds).

  3. Run commit

    The configuration is committed.

Updated: 2019-05-08

Document ID: EDOC1100004351

Views: 125290

Downloads: 295

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next