No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Ethernet Switching

CloudEngine 8800, 7800, 6800, and 5800 V200R003C00

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, MUX VLAN, Voice VLAN, VLAN mapping, QinQ, GVRP, VCMP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Setting the Link Aggregation Mode to LACP

Setting the Link Aggregation Mode to LACP

Context

Link aggregation can work in manual load balancing mode, static LACP mode, or dynamic LACP mode.

In LACP mode, you must manually create an Eth-Trunk and add interfaces to the Eth-Trunk. However, LACP controls active interfaces through negotiation.

Eth-Trunks in dynamic LACP mode are used only when a Huawei device connects to a server. For other scenarios, configuring Eth-Trunks in static LACP mode is recommended to reduce the chances of potential loops.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface eth-trunk trunk-id

    The Eth-Trunk interface view is displayed.

  3. Configure a working mode of the Eth-Trunk.

    Configure the static or dynamic LACP mode.

    • When the two directly connected devices support LACP, static LACP is recommended.

      Run mode lacp-static

      The Eth-Trunk is configured to work in static LACP mode.

      Before configuring an Eth-Trunk, ensure that both devices use the same working mode.

    • When a device is directly connected to a server, the dynamic LACP mode is often used. You can also use the static LACP mode.

      Run mode lacp-dynamic

      The Eth-Trunk is configured to work in dynamic LACP mode.

  4. Run commit

    The configuration is committed.

Translation
Download
Updated: 2019-05-08

Document ID: EDOC1100004351

Views: 128830

Downloads: 297

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next