No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Ethernet Switching

CloudEngine 8800, 7800, 6800, and 5800 V200R003C00

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, MUX VLAN, Voice VLAN, VLAN mapping, QinQ, GVRP, VCMP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Setting the Maximum Transmission Rate of an Interface

Setting the Maximum Transmission Rate of an Interface

Context

A larger value of packet-number indicates more BPDUs sent at a hello interval and therefore more system resources occupied. Setting the proper value of packet-number prevents excess bandwidth usage when route flapping occurs.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The view of the Ethernet interface that participates in spanning tree calculation is displayed.

  3. Run stp transmit-limit packet-number

    The maximum number of BPDUs sent by a port in a specified period is set.

    By default, the maximum transmission rate of BPDUs on an interface is the value configured by the stp transmit-limit (system view) command. If the stp transmit-limit (system view) command is not configured, an interface sends a maximum of six BPDUs per Hello Time interval.
    NOTE:

    If the same maximum transmission rate of BPDUs needs to be set for each interface on a device, run the stp transmit-limit (system view) command. The stp transmit-limit (interface view) command takes precedence over the stp transmit-limit (system view) command. If the stp transmit-limit (interface view) command is configured on an interface, the stp transmit-limit (system view) command does not take effect on that interface.

  4. Run commit

    The configuration is committed.

Translation
Download
Updated: 2019-05-08

Document ID: EDOC1100004351

Views: 127301

Downloads: 296

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next