No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Ethernet Switching

CloudEngine 8800, 7800, 6800, and 5800 V200R003C00

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, MUX VLAN, Voice VLAN, VLAN mapping, QinQ, GVRP, VCMP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
MSTP Fast Convergence

MSTP Fast Convergence

MSTP supports both ordinary and enhanced Proposal/Agreement (P/A) mechanisms:
  • Ordinary P/A

    The ordinary P/A mechanism supported by MSTP is implemented in the same manner as that supported by RSTP. For details about the P/A mechanism supported by RSTP, see Technical Details of RSTP.

  • Enhanced P/A

    Figure 10-10 Enhanced P/A mechanism

    As shown in Figure 10-10, in MSTP, the P/A mechanism works as follows:

    1. The upstream device sends a proposal to the downstream device, indicating that the port connecting to the downstream device wants to enter the Forwarding state as soon as possible. After receiving this BPDU, the downstream device sets the port connected to the upstream device as a root port and blocks all non-edge ports.

    2. The upstream device sends an agreement. After receiving this BPDU, the root port enters the Forwarding state.

    3. The downstream device replies with an agreement. After receiving this BPDU, the upstream device sets the port connected to the downstream device as a designated port, and the designated port transitions to the Forwarding state.

By default, Huawei network devices use the fast transition mechanism in enhanced mode. To enable a Huawei network device to communicate with a third-party device that uses the fast transition mechanism in common mode, configure the Proposal/Agreement mechanism on the Huawei network device so that it works in common mode.

Translation
Download
Updated: 2019-05-08

Document ID: EDOC1100004351

Views: 127308

Downloads: 296

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next